The Display
Device is designed
to be menu driven and
self-explanatory. Via
the menu system it’s
also possible to adjust
all the parameters,
to switch data recording
on/off, to choose the
desired display during
the work and to transfer
the recorded data to
a PC for further analysis
in an easy and simple
way using the EXPERT
2.1 software
package.
When
the device is connected
to a PC, it is possible
to do the software adjustments,
to memorize and to follow
the complete work on
the Kayak Ergo
in the Real-time mode.
Using
only 4 buttons (ENTER,
ESCAPE,
UP,
DOWN)
it is possible to perform
all the Display
Device functions.
It makes working with
the device easy and
simple.
Display
Device Main Characteristics
-
Backlight
-
Graphic
display
-
Rechargeable
battery with about
15 hours of authonomy
-
After
switching ON, the
last screen settings
appear
-
Navigate the functions
using menus
-
Display options including
graphical or numerical
data
-
Time, Stroke rate,
Power, Work, Force,
Heart rate
-
Choose
from a variety of
units - Power (W),
Energy (J) or Force
(N) - to be displayed
with bigger fonts
in the middle of the
display. Switch between
the units during a
work out using UP/DOWN
buttons
-
Heart
rate with Polar chest
belt and receiver
-
Pre-programming the
workouts with time, rest
time and numbers of
intervals
-
Store
workout data on the
board memory or just
work without recording
-
Recall
function
-
Memory status
-
Battery status
-
PC COM port interface.
(Serial port)
-
Real-time monitoring
on the performance
monitor or PC
-
The accuracy control
or calibration is
possible at any time
with PC
Display
Device Modes
Two
modes for presentation
of the measured and calculated
parameters are available:
Text
mode
In
text mode, it is possible
to follow five parameters
at the same time.
Time,
Stroke and Heart Rate
are standard fields that
are presented in all text
modes. Main and Average
field could be switched
to different views pressing
UP and
DOWN
buttons.
Following
views are avaliable: Power
[W], Forces
[N], Energy
[J], Graph mode.
Graph
mode
In
graph mode, two parameters
can be followed at once.
In
the upper part of the
display (Left & Right
Average Value) are numerical
values of the measured
parameters (POWER,
FORCE…)
and this values are refreshed
after each stroke. Left
& Right Graph represents
graphical interpretation
of the measured parametar.
Two bars at the middle
of the display are presentation
of the last stroke, shown
separatlyto allow easy
comparation of two sides
(left & right force,
left & right power
etc.).
In
graph mode, three different
views are avaliable. Two
of them are predefined
(Forces, Power & HR).
The last one is Custom
mode. Switching through
views can be done by pressing
ENTER
button.
Memory
capacity
Data
recorded during a session
is put in the memory.
It’s capacity depends
on the sampling rate (table
below). The Memory indicator
in the Status bar shows
the fullness of this memory.
|
Sample
rate |
High
(100 samples/sec) |
Medium
(50 samples/sec) |
Low
(25 samples/sec) |
Very
Low
(10 samples/sec) |
|
Capacity
|
14’30''
(870 sec) |
29’
(1740 sec) |
58’
(3480 sec) |
145’
(8700 sec) |
This
data can be transferred
to PC for further analyse
in Expert
2.1 software.
The
Recall memory has 30 hours
capacity. Average values
per minute of the following
parameters (Power,
Force,
Energy,
Stroke rate,
Heart rate)
are memorized in this
memory. |
